• Wilco Frac Fluid Mixer Trailer

    The Wilco™ frac fluid mixer trailer is designed for transporting 100 bbl of 8.6 lb/gal fluid and is equipped with an additive system that is used for circulation and high-rate discharge of fracturing fluids.


    Fill, circulate, and discharge your fluids with our versatile mixing-displacement manifold. This is designed to move fluid "from anywhere to anywhere" with one of the two Mission™ pumps on the trailer. You can move fluids to the mixer tank, blend and recirculate through two tanks, then displace to the treating fluid blender. Our manifold system is set up to perform a variety of different styles of blending and is latched to the trailer frame sides.

    Fluid may be added to the mix tanks by either of two methods: 

    1. Pumping fluid from another vessel via a 3-in. fill line into the top of the mixing vessel.
    2. Pumping, using the on-board 3×2×13 in. centrifugal pumps fluid via the 3-in. suction manifold.

    The fluid mixture within the mix tank can then be recirculated. The recirculated fluid flows through the mixing-agitation apparatus in the mix vessel. It is then pumped out the bottom of the vessel with a 3×2×13 centrifugal pump and then circulated back up through the top of the mixing tank. The process is continuous, and the recirculating fluid can be mixed with more fluid or additives, which can be added into the vessel via the top fill line or manually added through the manway.


    Two 50-bbl tanks, 102-in (8.5-ft) diameter

    • Two Mission centrifugal pumps, 3×2×13 in. impeller, mechanical seals
    • Three rows of paddle-style agitators in blender vessels designed to create toroidal flow within the blender
    • Agitators and centrifugal pumps are run with hydraulic motors
    • Work platform designed to allow front end loader equipment to deliver pallets of additive and bulk materials to work platform Safety rails on sides of work platform double as full opening gates.
    • Powered by Cat 6.6 Tier III or IV engine
    • Control panel stand for remote control of air actuated valves, engine, and hydraulic drives
    • Support and bracing technique used for tanks and work platform is designed to minimize vibration on the work platform
    • Straight, non-upset side beams to provide for support for heavier loads during transport or mixing
    • Work lights are all rectangular, 24-v LED lights. The top work area illuminated with four lights. Two lights are mounted on swivel arms over the batch mixers’ manways.
    • Two lights are also mounted underneath the work platform to light the area of the centrifugal pumps and the recirculation, fill, and discharge manifolds. A work light mounted on the front blender vessel and is directed to the power unit.
    • 2-in. weld-on king pin
    • Hazmat placards located at required positions 



    • Air suspension 50,000-lb tandem (25,000 each)
    • Dual tires are 11R22.5
    • Two landing gear legs have 62,500-lb lift capacity